Cyberlight Digital Datalink

Light Analog Module (LAM) Photon Transducer Interconnect

Revolutionary Fiber Optic Digital Datalink
Selecting the right datalink for the best digital signal transmission has become one of the most difficult decisions a digital audiophile must make. For the truly discriminating, the choice is fiber-optically clear: Red-jacketed CyberLight Photon Digital Datalink.

By adapting glass fiber and laser-like technology to the audio realm, Harmonic Technology has created a new generation of datalinks to bring the ultimate level of performance to digital audiophiles. Through patent-pending, miniaturized LAM (Light Analog Module) Photon Transducers, the CyberLight Digital Datalink takes the digital input of any kind and converts it directly to a Photon Density Modulated light pulse – avoiding any AD/DA conversions – and then transmits the encoded optical information back to its original digital format. The entire signal path is purely unidirectional, with no back reflection, in order to capture amazing clarity.

Total Impedance Control
Impedance matching is one of the most critical variables for a quality digital signal. The Cyberlight Digital Datalinks' LAM technology allows for total impedance control at all frequencies for maximum linearity – 75 ohms for coaxial cables and 100 ohms for AES/BU connections. Tightly controlling the impedance at both ends of the datalink prevents echoes within the cable and eliminates timing issues that cause jitter.

Ground-Breaking Technology
Figuratively and literally speaking, CyberLight technology is truly ground-breaking. The photon density modulated light signal actually does break the ground between components yielding a signal largely (or completely with the CyberLight Power Pack) unaffected by humming noise along the ground plane. With the signal path completely isolated from the ground, the CyberLight Digital Datalink ensures that there is no possibility of the cables passing noise between components, nor acting as an antenna for RFI or EMI induced distortions, which keeps the noise floor extremely low and reduces smearing. The Cyberlight Photon Transducer Digital Datalinks are truly an indispensable component for any home theater system. Please note: Because there are no physical wires built within the CyberLight Digital Datalink, an extra ground wire may be needed in order to ensure components are on the same ground level.

  Patent-pending LAM ensures digital signals remain in their original format
No extra digitization to offer the lowest possible noise floor
Inter-component ground-lift to eliminate radiated high frequency noise
Photo light signals make it immune to EMI and RFI interference
Full band-width frequency (between 5Hz to 30MHz) for superb depth and wide dynamic range
Tight control over impedance - 75 ohms for coaxial cables and 100 ohms for AES/EBU

CyberLight Connection Guide

Optimal Connections
CyberLight P2A Pre-amp-to-amp; source direct-to-amp
CyberLight Wave Source-to-preamp
CyberLight Digital Datalink Transport-to-processor